Your first Board

The Board shows several devices side by side as 3D models, each on its own simulator, so you can compare one screen across them.

Add devices

Open Devices in the top bar and tick the devices you want, or click Add device at the end of the filmstrip. Each one starts its own simulator, which takes about 3 GB of memory. While it starts, its place on the Board says so.

Drive them from one

With Sync on, touch any device’s screen. The others repeat each tap on the control with the same label, or on the same place when no label matches, and they repeat each swipe too. The device you touched last is the lead and is marked Lead. See Sync and the lead device.

Look at one device

Click a device’s name or its tile in the filmstrip, double-click it off its screen, or press ⌘1 to ⌘9. Press Esc or ⌘0 to go back to the Board.

Compare them

Click Snapshot all. Devicewing waits for every screen to settle, then saves each screen and one picture of the devices side by side at the same physical scale, each with its name under it.